Sox Assist

Using the Sox Assist

Watch our short video below...

Just wrap it around...

While seated comfortably, place the SoxAssist™ across your lap with the openings facing forward. Stretch your sock around the three right pegs as shown in the photos above. Adjust for your sock length and size by sliding the edges of the socks down the pegs until the opened heel of the sock is level with the tops of the pegs.

Repeat with the left sock on the left pegs.

Lower the SoxAssist to the floor.

...then flip it on!

Place one foot on the middle textured foot rest. Hold the device firmly in place and slide your other foot into the sock opening until your toes are all the way in. Next, simply angle your toes up and flip the sock away from the pegs. Repeat on the other side, and enjoy toasty warm feet!

The raised foot rest can also help you to tie your shoes—
Just place one foot onto the raised center platform. The angle will make it much easier to reach those shoelaces!

Placement of your Velcro® dots

Before using your SoxAssist, place the four included hook-sided Velcro dots on the top of each of the four front pegs as shown in the diagram. Place the loop-sided Velcro dots near the top of the two rear pegs, so that the dots face the back of the SoxAssist. These will help hold your socks in the proper position. (The hook-sided dots are on the clear paper, and the loop-sided dots are on the white paper.)
The dots achieve 80% bond strength in about an hour and full strength in 30 hours.